Solitaire 8 Multicomm 4


Multicomm Series 8 Zone Control Panel, Inbuilt IP, GPRS and GSM communicator, PSTN autodialer, Inbuilt Power Supply.

SEC 8S IGP

 

Features:

  • Micro-controller based
  • LCD display remote keypad
  • 3 status leds – armed, power and dialing
  • 16 key back lit key pad
  • Sleek white ABS body with key pad cover
  • Separate main control station for connection terminals and power supply unit
  • Two access codes – master and servant
  • Part arm facility
  • Automatic arming facility
  • Automatic disarming facility
  • Can be operated through cellular mobile telephone
  • Number of rings after which panel responds is programmable
  • Panel can be armed and disarmed through telephone
  • Built in battery backup provision
  • Zone omitting facility
  • Individual zone status is indicated on display
  • Individual entry delay time 2 to 255 seconds
  • Individual exit delay time 2 to 255 seconds
  • Sounder time 2 to 20 minutes
  • Silent arming
  • Night mode arming
  • Intrusion log
  • Dedicated panic, fire and quick arm keys
  • Power failure indication
  • Blown fuse indication on LCD display
  • Non-volatile memory
  • Open zone indication on lcd display
  • Automatic re-arming after an intrusion
  • Only three incorrect code attempts allowed to disarm the system after which the system goes into alarm state
  • Multiple sounder outputs
  • Armed light relay output
  • Inbuilt Digital Communicator with IP, GPRS and GSM communication
  • Option to select IP, GPRS and GSM communication
  • Failover logic programmable
  • IP and GPRS communication over SIA protocol, connects with universal monitoring stations.
  • Alarm information sent over IP, GPRS, SMS.
  • System status information sent over IP, GPRS, SMS.
  • Configurable IP settings
  • Heart beat message sent periodically
  • Inbuilt autodialer
  • 2 messages
  • Separate intrusion message
  • Separate fire message
  • 15 telephone numbers for intrusion message
  • 15 telephone numbers for fire message
  • 20 second recording time for each message
  • Operates with both tone & pulse
  • Message playback
  • Silent Dialing
  • Can work on EPABX
  • Non-volatile memory
  • Line overriding
  • Inbuilt tamper switch
  • Inbuilt Switch Mode Power Supply
  • Main control station housed in elegant white ABS body

Datasheet

Technical Specification

ELECTRICAL
REMOTE KEY PAD ONLY
Quiescent current 25 mA
Quiescent current with backlit LCD 45 mA
MAIN CONTROL STATION WITH ONE REMOTE KEY PAD
Quiescent current: 1800 mA
Quiescent current with backlit LCD: 1925 mA
Current with dialing: 140 mA
Maximum sounder 1 current output: 1A
Maximum sounder 2 current output: 1A
Sounder saturation Voltage: < 1V at 1A
Remote keypads: Up to six
Non-volatile Memory: Programming and Log
Zone response time: <500ms
Zone Loop Resistance: <5k ohm for NORMALLY CLOSED
Load switch output can take 12V relay to control any mains load


POWER SUPPLY
Mains supply Voltage: 220+10%-15% 50Hz
Total current Output: 3000mA at 220V AC (Fuse JA 20mm On Main Card)
Regulation: <9%
Ripple: <220mV RMS
Battery Voltage: 12V DC
Battery type: SMF Rechargeable
Battery Recharge Voltage: 13.8V +/-0.2V DC
Fuse: 250ma 20mm AC Mains on PS Card
ENVIRONMENTAL
Operating Temperature: 0C to 45C
Storage Temperature: -20C to 60C
Maximum humidity: 95% non-condensing
Environment residential / commercial / light Industrial


PHYSICAL
REMOTE KEY PAD
Dimensions: 148mm x 130mm x 33mm

MAIN CONTROL STATION
Dimensions 236mm x 226mm x 80mm
Max Battery Dimensions: 150mm x 110mm x 64mm

Download